Problem with Visio 2003

12:55 AM

I was working on a figure and when i copied the figure from MATLAB and pasted in the visio by using CTRL C+ CTRL V the result was a faded figure. The solution is that save the figure as a jpg or png and then insert it into visio using INSERT > PICTURE> From file.



Before
After

You Might Also Like

0 comments

Copyright statement

Copyright © 2015-2017 by Hadeed A Sher

All rights reserved. No part of this blog may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without my prior written permission. For permission requests, write to the blog author addressed “Attention: Permissions Coordinator,” at the contact form.


Disclaimer

This blog is about my PhD work and an archive to my engineering education. However, additional study material for the courses i teach and that i have studied is also archived here.
All the circuits in this blog are tested by myself under specific conditions. BE CAREFUL if you are experimenting them, the blogger and this blog are not responsible to any harm and or damage to yourself and your equipment.


Contact form

Name

Email *

Message *