­
6N137

Experimental work | Circuit for 6N136-6N137 optocoupler

Connect the input signal between pins 2 and 3. Use a sutiable resistor for current limiting. I used a 58 ohm resistor in series with pin 2. Connect Pin 8 with Vcc and Pin 5 with ground.  Connect a 0.1uf polar capacitor between pin 8 and 5.  Connect a load resistor between pin 8 and pin 6. I used 2.6kohm Connect a 15...

Continue Reading

4 comments
May 27, 2015 by

Copyright statement

Copyright © 2015-2017 by Hadeed A Sher

All rights reserved. No part of this blog may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without my prior written permission. For permission requests, write to the blog author addressed “Attention: Permissions Coordinator,” at the contact form.


Disclaimer

This blog is about my PhD work and an archive to my engineering education. However, additional study material for the courses i teach and that i have studied is also archived here.
All the circuits in this blog are tested by myself under specific conditions. BE CAREFUL if you are experimenting them, the blogger and this blog are not responsible to any harm and or damage to yourself and your equipment.


Contact form

Name

Email *

Message *