­
First order circuits

First order RC circuit simulation in Orcad

PrevNext
We can perform the simulation in following steps. 1. Design the circuit. 2. Choose the switch from Analog_Misc>Swt_close/open. 3. Choose from the Special>PARAM and place it with the layout. 4. Right click on the resistance and add the value as {OHM}. 5. Double click on the parameter and add new property and name it OHM and value 1. This is the initial value....

Continue Reading

No comments
Nov 16, 2018 by

Copyright statement

Copyright © 2015-2017 by Hadeed A Sher

All rights reserved. No part of this blog may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without my prior written permission. For permission requests, write to the blog author addressed “Attention: Permissions Coordinator,” at the contact form.


Disclaimer

This blog is about my PhD work and an archive to my engineering education. However, additional study material for the courses i teach and that i have studied is also archived here.
All the circuits in this blog are tested by myself under specific conditions. BE CAREFUL if you are experimenting them, the blogger and this blog are not responsible to any harm and or damage to yourself and your equipment.


Contact form

Name

Email *

Message *